Elica EVL43XS1 安装指导

CAUTION: Before replacing the lamps, disconnect power off 

to prevent from being switched on accidentally.

Use a Phillips # 2 screw driver to remove the lamp   

 

cover.  Remove it  carefully from its housing.

 

 
 
 
 
 
 
 
 
 
 
 
 

 
 

Remove the damaged lamp bulb (turn counter  

clockwise) and replace it with a new bulb. E12 Philips

Lamp 120V, 40W. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 

If the model is not vented to the outside, the air will be recir-

culated through disposable charcoal filters that help remove

smoke and odors.

The charcoal filters cannot be cleaned.

They must be replaced.

Cover the grill that protects the suction motor with the carbon 

filter so that the slots on the filter correspond to the pins on

the sides of the motor protection grill.

Turn the carbon filter clockwise to block them (bayonet fixing).

The charcoal filters should be replaced every 4-6 months

(depending on hood usage).

NOTE: DO NOT rinse, or put charcoal filters in an automatic

dishwasher.

NOTE: Charcoal filters are not included with the hood.

They must be ordered from your supplier.

Order the needed kit specifying your hood model and width

size.

1.

2.

Assemble the air deflector with the duct cover bracket 

 

with 2 - assembly screws provided. 

 

              

A

C

B

B

Measure from the bottom of the air deflector to the  

 

bottom of the hood outlet. 

 

                     

X

A

C

D

B

E

 

 

 

 

 

Cut the duct to the measured size (X).

Remove the air deflector.

Slide the duct onto the bottom of the air deflector.

Place the assembled air deflector and duct over the 

 

exhaust outlet from the hood.

Reassemble the air deflector to the duct cover bracket 

 

with 2 assembly screws.

Seal connections with vent clamps.

1.

2.

3.

4.

5.

6.

7.

8.

A. Vent cover bracket

B. 2.9 x 6.5 mm screws

C. Deflector

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet