Elica EVL43XS1 安装指导

Install framing for hood support

If drywall is present, mark the screw hole locations.

Remove the template.

Cut away enough drywall to expose 2 vertical studs at

the holes location indicated by the template.

Install two horizontal supports at least 4 X 2” between

two wall studs at the bottom and upper mounting holes

installation location.

The horizontal support must be flush with the room side

of the studs.

Use cleats behind both sides of the support to secure to

wall studs.

Reinstalll drywall and refinish

IMPORTANT- Framing must be capable of supporting 100 lbs.

Mounting the hood

WARNING: 2 people are required to lift and position the hood

onto the mounting screws.

Place the template on the wall along the horizontal line,

make sure the template is leveled and centered with the

centerline.

Mark “upper” screw holes locations in the wall.

IMPORTANT. Check to be sure that hole locations are

leveled and correctly centered by the vertical centerline.

Drive “upper” wood screws by hand. Leave ¼ “ of

distance between the screw head and the wall.

Remove the grease filter and mount the hood onto the

“upper” screws.

•

6 -1/2” min. opening for ductwork

View from rear

cleats

1” x 6” min

Mounting Support

Centerline of

installation

space

Mark “lower” wood screw holes locations in the wall using

a pencil.

Remove the hood.

Drive “lower” wood screws, by hand. Remove screws.

Mount the hood onto the “upper” screws.

Drive and tighten the “upper” wood screws, by hand.

Drive and tighten the “lower” wood screws, by hand.

Connecting the ductwork

Install ductwork, making connections in the direction of

airflow as illustrated.

Push duct over the exhaust outlet.

Wrap all duct joints and the flange connections with duct

tape for an airtight seal.

Make the same connection in the wall or ceiling vent exit.

•

A. Airflow
B. Duct tape over seam