Elica ERS63XSS 安装指导

6.  Measure distance “X” from the cabinet floor to the top of the 

 

countertop. Subtract 28

1

⁄

2

” from distance “X” to determine  

 

dimension “Y” (X - 28

1

⁄

2 

= Y).

7.  Attach the support legs to the side of the vent box with 

 

4 - 4 x 8 mm screws in each support leg. Adjust to dimension 

 

“Y” from the bottom of the vent box to the bottom of the support 

 

legs. Tighten screws. 

A. Motor box

B. Support leg

C. Installation screws

 

When installed in a cabinet, vent system can exhaust through the

bottom, right or left of the cabinet.

IMPORTANT: When using the 6” (15.2 cm) vent transition (supplied) 

for 6” round venting, only left or right venting is recommended.

NOTE: If installing the vent damper in the down position, a wall or

roof cap with a damper at the exit end of the vent system is required.

•

Downdraft vent is shipped with blower in down venting position so 

 

no modification is required.

•

If rear mounting of the blower motor is not required, go to the 

 

“Complete Installation” section.

•

To mount the blower motor to the rear side of the vent box, go to 

 

the “Rear Mounting - Blower Motor” section.

1.  Using two or more people, place the downdraft vent system on its 

 back.

2.  Remove the 4 screws from the cover plate mounted to the face of 

 

the motor box and set them aside.

A.Cover plate

B. Cover plate screws

C. Cover plate keyhole slot shoulder screws

D.Motor mounting screws

E. Vent cover plate

F. Motor box

G. Vent cover screws

3.  Slide the cover plate up and slip it over the keyhole slot shoulder 

 

screws. Set the cover aside.

4.  Remove 4 screws from the bottom of the motor box that hold 

 

the motor assembly to the motor box. 

 

NOTE: Disconnect the electrical wiring connection from motor if 

 needed.

5.  Remove 3 screws and the vent cover plate from the left or right 

 

side of the motor box for the venting direction to be used.

6.  Rotate the blower motor assembly 90 degrees to the left or right  

 

side to the chosen venting direction and secure to the blower box 

 

with motor mounting screws previously removed. Do not twist or 

 

bind the wires.

7.  Install the vent cover plate over the rectangular opening in the 

 

bottom of the motor box and secure with vent cover screws. 

 

NOTE: Reinstall the electrical wiring connection to motor if 

 removed.

8.  Reinstall the cover plate to the face of the motor box and secure 

 

with 4 cover plate screws previously removed.

9.  For mounting the blower motor to the back of the vent box, go 

 

to the “Rear Mounting - Blower Motor” section. Otherwise, go to 

 

the “Complete Installation” section.