Husqvarna 325P5X 用户手册

English

 – 15

•

Tighten the knob.

Undo the knob (at least three turns).

•

Push the knob towards the coupling.

•

Carefully twist the upper shaft to unlock it.

•

Hold both parts of the shaft and pull the upper shaft out of 
the coupling.

If the machine has a protective guard bolted under the engine 
this should be removed before the impact guard is 
assembled.

Fit the guard using the three screws and washers. Fit the two 
short screws in hole A. Tighten the screws to a torque of 4 
Nm. After the machine has been in use for around 20 hours, 
re-tighten the screws to 4 Nm.

•

Make sure the knob is loose.

•

Align the cut-out in the upper shaft with the coupling's lock 
plate on the lower shaft. The parts then lock together.

•

Tighten the knob.

•

Undo the knob (at least three turns).

•

Push the knob towards the coupling.

•

Carefully twist the upper shaft to unlock it.

•

Hold both parts of the shaft and pull the upper shaft out of 
the coupling.