Mitsubishi lt-3280 Owner's Manual

Note:  Transport  buttons (rewind, play forward, stop, 
pause and record) on the remote control are located in 
the bottom section of the remote control.

If multiple digital recording devices are available in 
NetCommand, this setting allows you to choose the 
device to use when recording digital programs.  A 
digital recording can be made on either a digital or 
analog device although the quality will not be as good if 
recorded on an analog device.  For best playback quality, 
record digital programs on a digital recording device.  

If multiple devices were not connected and then added 
in the NetCommand setup, this setting will be unavailable 
(grayed out).  Analog recordings can only be made on the 
one analog device connected to Monitor Out  (usually a 

VCR) and are not affected by this setting. This feature is 

most useful when recording from  ChannelView™ (page 

57). 

The Icon Order screen allows you to arrange the device 

icon order on the Device Selection menu to a different 
sequence, for ease of selection and operation.  To 
change the order, press ADJUST     

 

  to highlight 

the icon to be moved and then press ENTER.  Press 

ADJUST     

 

  to move the icon to the desired 

position and then press ENTER to release the icon.

NetCommand uses the Transport menu to control the 

VCRs, DVDs, IEEE 1394 AV Discs, digital VCRs, and 

similar devices.  If you choose to turn off this menu when 

viewing the devices, the transport buttons (rewind, play 
forward, stop, pause and record) on the media center’s 

remote control will continue to operate these devices.  In 
the Device Selection menu selecting a VCR or DVD Player 

will automatically display the Transport menu.  You can 

re-display this menu by pressing DEVICE MENU.

Select Transport menu functions by pressing ADJUST   
or    and then ENTER.  For example, to pause playback, 

press ADJUST   or   to move to PAUSE, then press 
ENTER.  If a function is not possible, such as record for a 
DVD Player, the Transport menu button will be grayed out.  

Detailed information regarding setting up and editing 
the NetCommand menu is found in Chapter 3. The Edit 
NetCommand screens allow you to add new devices, 
change or edit traditional and IEEE 1394 devices, 
turn devices and unused inputs On or Off, set up TV 
Guide On Screen®, delete a single device or delete the 
entire setup configuration.  If you choose to delete the 
entire configuration, or if the NetCommand setup was 
cancelled, deleted or not completed, you can start at the 
Initial NetCommand screen.  The Review screen shows 
all devices connected to the media center.