Whirlpool WGD7300X User Manual

9. Attach other end of long hose to fill valve at bottom of dryer back 

panel. Screw on coupling by hand until it is seated on fill valve 
connector. 

10. Using pliers, tighten the coupling an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

11. Check that the water faucets are on.

12. Check for leaks around “Y” connector, faucet, and hoses.

Check the levelness of the dryer by first placing a level on the top 

 

of the dryer near the console.  

Then, by placing a level in the crease on the side of the dryer 
between the top of the dryer and the dryer cabinet, check 

 

the levelness from front to back.

If the dryer is not level, prop up the dryer using a wood block. Use a 
wrench to adjust the legs up or down and check again for levelness.

1. Check that all parts are now installed. If there is an extra part, 

 

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials. 

4. Check the dryer’s final location. Be sure the vent is not crushed

 

 or kinked.

5. Check that the dryer is level. See “Level Dryer.”

6. Remove the blue film on the console and any tape remaining 

 

on the dryer.

7. Wipe the dryer drum interior thoroughly with a damp cloth 

 

to remove any dust.

8. Read  the “Dryer Use” section in your Use and Care Guide.

9. For power supply cord installation, plug into a grounded outlet. 

10. Check that gas supply is on.

11. Check for leaks.

12. Select a Timed Dry heated cycle, and start the dryer. Do not select 

the Air Only Temperature setting.

■

Controls are set in a running or “On” position.

■

Start button has been pushed firmly.

■

Dryer is plugged into an outlet and/or electrical supply 

 

is connected.

■

Household fuse is intact and tight, or circuit breaker 

 

has not tripped.

■

Dryer door is closed.

This dryer automatically runs an installation diagnostic routine 

 

at the start of its first cycle.

NOTE: You may notice an odor when the dryer is first heated. This 
odor is common when the heating element is first used. The odor 
will go away.

You can change your door swing from a right-side opening 

 

to a left-side opening, if desired.

 

1. Place a towel or soft cloth on top of dryer or work space

 

to avoid damaging the surface.

1. Open the dryer door.

2. Remove the bottom screw from each of the 2 hinges 

 

that attach dryer door to front panel of dryer.