Vanguard Managed Solutions 7300 Series Benutzerhandbuch

Modifying Your Vanguard 7300 

5-15

This section describes how to install an Ethernet PCI PMC onto the IBM750FX CPU 
card. The IBM750FX CPU card provides two PMC connectors. Figure 5-10 shows 
the location where PMCs can be installed:

Release 6.4 and greater supports the IBM750FX CPU that does not require a 
Pre-installed Memory PMC. The IBM750FX CPU card has On-board memory.

To add a 10/100BaseT Ethernet PMC, install the first PMC in the IBM750FX CPU 
Card PCI PMC. Use the steps in this table to install the Ethernet PMC on the CPU 
Card:

To remove a 10/100BaseT Ethernet PMC, reverse the steps in this table:

Power off the Vanguard 7300.

Disconnect any cables attached to the front of the CPU card.

Using a screwdriver, loosen the captive screws from the front of the CPU 
card.

To eject the CPU card, press the ejector levers outward simultaneously.

Pull the CPU card from the enclosure.

Be sure to place the CPU card on a clean, grounded, and static-free surface.

Avoid touching areas of integrated circuitry; static discharge can damage 
these circuits.

Remove the filler panel from the PCI PMC location on the front of the CPU 
card by gently pushing it out from the back of the rail.