Avaya 03-300430 User Manual

1139

ABRT

The packet bus in the PN where this EI circuit pack resides has a major 
alarm against it. This test needs to use the alarmed port network’s packet 
bus.

1. Enter display alarms and resolve any PKT-BUS alarms.
2. Retry the command.

1141

ABRT

The Packet Interface circuit pack is out of service.

1. See 

on page 1799 for the recommended 

repair procedure.

1144

ABRT

The PN’s packet bus has a major alarm against it. This test needs to use 
the alarmed PN’s packet bus.

1. Enter display alarms and resolve any PKT-BUS alarms.
2. Retry the command.

1394

ABRT

The EI circuit pack is out of service and the test cannot be run. This 
condition is due to a change in the EI circuit pack’s ability to communicate 
with the EI or SNI circuit pack on the other end of the fiber.

1. Run Test #237 and check the Error Log for EXP-INTF Error Type 1281. 

If Error Type 1281 is present or if Test #237 does not pass, see the 
repair procedures for Test #237, in 

2. If Test #237 passes, rest the EI pack. Note that this will not be 

destructive to the port network where EI circuit pack resides because it 
will not be serving as the expansion Archangel if it is not in service.

3. Repeat this test. 

1395

ABRT

This test cannot be run on an EI circuit pack if it is part of the B-side PNC 
and duplicated PNC is not enabled.

1. If this test needs to run on this EI circuit pack, use change 

system-parameters duplication to enable PNC.

2. Use set pnc lock to prevent the system from doing a PNC 

interchange.

3. Repeat this test.

 3 of 5