Avaya 03-300430 User Manual

2100

ABRT

Could not allocate the necessary system resources to run this test.

2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

ANY

FAIL

The transmitted data packet was not received correctly by the Packet 
Interface circuit pack. The failure may be in the EI under test, the DS1 
converter circuit packs, or the intervening Center Stage components.

1. Test the Packet Interface circuit with test packet-interface CS 

where “C” is the IPSI’s carrier in a high- or critical-reliability system, and 
“S” is the slot number where the IPSI’s Packet Interface resides. If the 
Packet Interface circuit fails any tests, see 

2. If the EI under test resides in a high-reliability system’s PN, 

(2 PN-to-CSS fibers in an unduplicated PNC), run the short test 
sequence on both of the PN’s EI boards, and follow procedures for 
Test #589.

3. Enter display errors and resolve any PKT-BUS errors.
4. Perform the 

 in 

 in Maintenance Procedures (03-300192).

PASS

Although this test has passed, there may be related problems on other EIs 
used in connectivity to and from this EI. Software may have conducted 
tests on these other components and determined that this board was 
functioning properly and any problems were probably due to a problem with 
some other connectivity component. Check the error and alarm logs for 
problems with other EI circuit packs and resolve these errors.

1. Refer to other EI board tests if the link is not functioning correctly.

0

NO 

BOARD

No board was detected by the test.

1. Resolve either wrong board (Error 125) or no board (Error 131) issues.

2. Check that the board is properly translated and inserted. If so, check for 

hyperactivity (Error 1538). If hyperactive, use reset board 
location.

3. Run the test again. If it fails, the ID chip on board may be bad. Replace 

the board and retest.

 5 of 5