Avaya 03-300430 User Manual

2306

ABRT

An SNI circuit pack on the fiber link is not responding to test requests sent 
by software.

1. Run the test led switch-node for the switch node(s) where the 

SNI(s) reside to verify whether the LEDs on the board(s) light. Follow 
the steps below for the SNI(s) that had no LEDs light.

2. If the LEDs on the other boards in the carrier light, but the LEDs on this 

board do not light, run Test #760 via test board location l for 

the active SNC in this carrier. Wait 5 minutes and then try step 1 one 
more time. If the LEDs on this board still do not light, replace the 
board. (Replacing an SNI may be service interrupting. Refer to the 
SNI-BD section for the procedure to replace an SNI.)

3. If none of the LEDs light for the boards in the same carrier as this 

board, fix any problems associated with the connectivity of this carrier 
to the media server. Use list fiber-link to determine the fiber 

connections to this carrier. Check the LEDs on every SNI and EI, and 
fix any fiber problems. Enter display errors and resolve any 

EXP-INTF error entries associated with the PN. Also, resolve any 
SYNC, SNI-BD, SNC-BD, FIBER-LK, or SNI-PEER error entries.

2500

ABRT

Internal system error If this fiber link has two SNI endpoints, run test 
board location separately for each SNI and follow the repair 

procedures in section SNI-BD. Use list fiber-link to see a fiber 

link’s endpoints. Otherwise:

1. Retry the command at 1-minute intervals up to 3 times.

102

FAIL

The SNI circuit pack (Endpoint 1) cannot communicate with the equipped 
SNI in slot 2. Use list fiber-link to see a fiber link’s endpoints.

1. Perform the 

 in 

 in Maintenance Procedures (03-300192). This should 

resolve multiple SNI-PEER errors.

2. If the SNI being tested has SNI-PEER Error Type 1, replace the SNI 

being tested. (Replacing an SNI may be service interrupting. Refer to 
the SNI-BD section for the procedure to replace an SNI.) To view 
SNI-PEER errors, use display errors with category PNC-PEER. 

Retry the command.

3. If the SNI being tested still has SNI-PEER Error Type 1, replace the 

SNI in slot 2.

 2 of 22