Avaya 03-300430 User Manual

1018

ABRT

Test disabled by administration. This only applies to analog stations.

The default for this field is ‘y,’ so you may want to determine why it has been 

turned off for this station.

1. To enable test, set the Test field on the station administration screen 

for the particular analog station being tested to y. Use change 
station extension.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2020

ABRT

The test did not run due to an already existing error on the specific port or 
a more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit 

pack and attempt to diagnose the already existing error.

2100

ABRT

Could not allocate the necessary system resources to run this test. This 
could be due to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

This test can fail due to on-board or off-board problems. Off-board 
problems of concern include EXP-PN, EXP-INTF, RMC-ENV faults, 
TDM-BUS faults, and faults associated with the tone detectors/tone 
generators. Clear every off-board problem before replacing the board. 
Keep in mind that a TDM-BUS problem is usually the result of a faulty 
board connected to the backplane or bent pins on the backplane.

1. Resolve any “EXP-PN, RMC-ENV,” or “EXP-INTF” errors in the error 

log.

2. Resolve any “TDM-BUS” errors in the error log.

3. Retest the board when the faults from steps 1 and 2 are cleared.

PASS

The port is correctly using its allocated time slots. User-reported troubles on 

this port should be investigated using other port tests and by examining 

station, trunk, or external wiring.

 3 of 4