Avaya 03-300430 User Manual

This test is destructive.
This test is only run as a part of a reset board procedure. For the Media Resource, use the 
change ip-interface screen to disable the Media Resource’s IP interface before 

performing this procedure.
A reset of this circuit pack takes about 3½ minutes.

FAIL

The circuit pack failed to return the circuit pack code or vintage.

1. Retry the command up to 5 times.

2. If the problem continues, replace the circuit pack.

3. Retry the command up to 5 times.

PASS

Communication with this circuit pack is successful.

0

NO 

BOARD

The test could not relate the internal ID to the port (no board). This could 
be due to incorrect translations, no board is inserted, an incorrect board is 
inserted, or an insane board is inserted.

1. Ensure that the board translations are correct. Administer the IP Media 

Resource interface if it is not already administered.

2. If the board was already administered correctly, check the error log to 

determine whether the board is hyperactive. If this is the case, the 
board is shut down. Reseat the board to reinitialize it.

3. If the board was found to be correctly inserted in step 1, enter 

busyout board location.

4. Enter reset board location.
5. Enter release board location.
6. Enter test board location long.

This should re-establish the linkage between the internal ID and the port.

 2 of 2