Avaya 03-300430 User Manual

This test sends port level translation data from the switch processor to the DS1 interface circuit 
pack or media module to assure that the trunk’s translation is correct. The port audit operation 
verifies the consistency of the current state of trunk kept in the DS1 interface circuit pack or 
media module and in the switch software.

ABRT

Internal system error

1018

ABRT

Maintenance is disabled on this trunk.

1. Enable maintenance by entering y in the Maintenance Tests field 

on the change trunk-group form.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

FAIL

Test failed due to internal system error.

1. Retry the command at 1-minute intervals up to 5 times.

PASS

Trunk translation has been updated successfully. The current trunk states 
kept in the DS1 interface circuit pack or media module and switch software 
are consistent.

If the trunk is busied out, the test will not run, but will return PASS. To verify 

that the trunk is in-service:

1. Enter status-command to verify that the trunk is in-service. If the 

trunk is in-service, no further action is necessary. If the trunk is 
out-of-service, continue to Step 2.

2. Enter release-trunk to put trunk back into in-service.
3. Retry the test command.

 1 of 2