Avaya 03-300430 User Manual

This is a series of six tests that are classified as audits. The media server sends messages to 
the on-board microprocessor to perform the tests. These audits run only if the station is 
in-service.

●

Switchhook Inquiry test: This updates the media server’s records according to the circuit 
pack’s records. This inquiry is sent all the way to the voice terminal.

●

Bad Scan Inquiry test: This sends an up-link message containing a generated count based 
on certain events relating to the link’s conditions. This indicates communications problems 
between the media server and Digital Port circuit pack.

●

EPF/PTC Inquiry test: This sends an up-link status message of the Electronic Power Feed 
(EPF). Possible conditions are: EPF-on-ok, EPF-off.

●

ID Request test: This sends a status request to the station. The station returns its 
configuration information and health information. The information is checked, and a pass/
fail result is provided.

●

Ringer update: This updates the digital telephone’s ringer state according to the media 
server’s records.

●

DTMF Administration update: This sends the digital station a message to refresh its default 
value (sending touch tones only) in the primary information channel. This value is initially 
set when the station is put in-service and each time the station’s state changes from 
another state to in-service.

PASS

The message to light every station lamp was sent successfully to the port.

1. Observe the station lamps being lit when running the test. If every 

lamps does not light, the other Digital Line test results may indicate 
related problems that do not allow the lamps to light.

2. Investigate by using other Digital Line port tests, and by examining the 

station, wiring, and connections.

 3 of 3