Avaya 03-300430 User Manual

1020

ABRT

The test did not run due to an already existing error on the specific port or 
due to a more general circuit pack or media module error.

1. Examine the error log for existing errors against this port or the circuit 

pack or media module and attempt to diagnose the already existing 
error.

2. Retry the test.

1040

ABRT

The test is invalid for this trunk port because it is administered as an 
access endpoint.

1. Use display port location to verify that this port is administered 

as an access endpoint. In this case the test should abort.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2053

ABRT/

FAIL

At least one of the following errors is found on the DS1 circuit pack or 
media module: 1281 – Loss of Signal, 1793 – Blue alarm, 2049 – Red 
alarm, 2305 – Yellow alarm, or 1537 – Hyperactivity.

1. Look for the previous Error Types in the Hardware Error Log, and 

follow the procedures given in the appropriate DS1-BD, UDS1-BD, or 
MG-DS1 maintenance documentation for the listed Error Types.

Earlier G1 software versions reported Error Code 2053 as a FAIL.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

 3 of 5