Avaya 03-300430 User Manual

This test is nondestructive.

Note:

Tests #844–848 are not supported on an International switch.

These tests are run by the Automatic Transmission Measurement System (ATMS). They are not 
part of the long or short trunk test sequences. Instead, they are run on demand with the test 
analog-testcall command or as part of ATMS scheduled testing. For more information, see 

 in Maintenance Procedures (03-300192).

The test call is run from an analog port on a TN771 Maintenance/Test circuit pack. It attempts to 
seize a port and make a call to a terminating test line (TTL) on the trunk’s far end. Transmission 
performance measurements are made and compared to administered thresholds. Errors are 
generated when results fall outside of “marginal” or “unacceptable” thresholds. Detail and 
summary measurement reports are obtainable using the list testcalls command.

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call.

1. Use display port location to determine the trunk group/member 

number of the port. Use status trunk to determine the service state 

of the port. If the service state indicates that the port is in use, then the 
port unavailable for this test. (Refer to section on “status” commands in 
Maintenance Commands Reference (03-300191) for a full description 
every possible state). Wait until the port is idle before retesting.

2. If the port status is idle, then retry the command at 1-minute intervals 

up to 5 times.

1001

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate timeslots for the test. The system may be 
under heavy traffic conditions or it may have timeslots out of service due to 
TDM bus errors.

1. If the system has no TDM bus errors and is not handling heavy traffic, 

repeat test at 1-minute intervals up to 5 times.

 1 of 5