Avaya 03-300430 User Manual

Note:

: On the G700, this test aborts with Error Code 1412.

The NPE Crosstalk test verifies that this port’s NPE channel talks on the selected time slot, and 
does not cross over to time slots reserved for other connections. If the NPE is not working 
correctly, 1-way and noisy connections may be observed. This test is usually part of a port’s 
long test sequence and takes 20 to 30 seconds to complete

ABRT

System resources required for this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 
be in use on a valid call. Use status access-endpoint extension to 

determine when the port is available for testing.

1. Retry the command at 1-minute intervals up to 5 times.

1001

ABRT

System resources required for this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate time slots for the test. The system may be 
under heavy traffic conditions or it may have time slots out-of-service due 
to TDM-BUS errors. Use status health to determine whether the 

system is experiencing heavy traffic.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

retry the command at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test. The system may 
be too big for the number of Tone Detectors present, or some Tone 
Detectors may be out of service. Use list measurement 
tone-receiver to show information about the system’s tone receivers.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the command at 1-minute intervals up 

to 5 times.

 1 of 2