Avaya 03-300430 User Manual

1004

ABRT

The port was seized by a valid call during the test. The test has been 
aborted.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If the 

port is active, it is unavailable for certain tests. Wait until the port is idle 
before testing.

2. Retry the command at 1-minute intervals up to 5 times.

1005

ABRT

This condition indicates that the test is not applicable when the analog port is 

used in a combined modem pool. This error can be ignored.

1018

ABRT

Test disabled via administration.

1. To enable the test for the particular analog station being tested, enter 

change station extension.

2. Enter y in the Test field.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2012

ABRT

System could not respond to this request.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

The NPE of the tested port was found to be transmitting in error. This 
causes noisy and unreliable connections.

1. Replace the circuit pack.

PASS

The port is correctly using its allocated time slots. User-reported troubles on 

this port should be investigated by using other port tests, by examining 

station wiring, or by examining the station.

 2 of 2