Avaya 03-300430 User Manual

1018

ABRT

The test has been disabled by administration. The default for the Test field 
on the station screen is y. Determine why this field has been set to “no” on 
this station (this may be due to the ringing application Test #48, that can 
be customer or terminal disturbing.

1. To enable the test for a particular station being tested, enter change 

station extension and set the Test field on the station screen to 

y.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

System resources required to run test are not available. This could be due 
to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

This test can fail due to either on- or off-board problems. Off-board 
problems include EXP-PN and EXP-INTF faults, (

: RMC-ENV 

faults), TDM-BUS faults, and faults associated with the Tone Detectors/
Tone Generators. Clear every off-board problem before replacing the 
board. A TDM-BUS problem is usually the result of a faulty board 
connected to the backplane, or bent pins on the backplane.

1. Resolve any EXP-PN and EXP-INTF errors.

: Resolve any RMC-ENV errors.

2. Resolve any TDM-BUS errors.

3. Resolve any TONE-BD or TONE-PT errors.

4. Test the board when the faults from steps 1, 2, and 3 are cleared. 

Replace the board only if the test fails.

PASS

The port is correctly using its allocated time slots. User-reported troubles on 

this port should be investigated by using other port tests, by examining 

station wiring, or by examining the station.

 3 of 4