Avaya 03-300430 User Manual

1001

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate time slots for the test.  The system may be 
under heavy traffic conditions or it may have time slots out-of-service due to 
TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

retry the command at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test.  The system may 
be oversized for the number of Tone Detectors present or some Tone 
Detectors may be out-of-service.

1. Resolve TTR-LEV errors.

2. Resolve TONE-PT errors.

3. If neither condition exists, retry the command at 1-minute intervals up to 

5 times.

1004

ABRT

The port was seized by a valid call during the test.  The test has been 
aborted.

1. Use display port location to determine the trunk group/member 

number of the port.  Use status trunk to determine the service state 

of the port.  If the port is active, wait until it is idle.

2. Retry the command at 1-minute intervals up to 5 times.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2020

ABRT

The test did not run due to a previously existing error on the specific port or 
a more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit 

pack and attempt to diagnose the previously existing error.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 3