Avaya 03-300430 User Manual

1002

ABRT

The system could not allocate time slots for the test.  The system may be 
under heavy traffic conditions or it may have time slots out-of-service due 
to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy 

traffic, retry the command at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test.  The system 
may be oversized for the number of Tone Detectors present, or some 
Tone Detectors may be out of service.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the command at 1-minute intervals up 

to 5 times.

1004

ABRT

System resources required to run this test are not available.  The port may 
be busy with a valid call.

1. Use display port location to determine the trunk group/

member number of the port.  Use status trunk to determine the 

service state of the port.  If the port is active, wait until it is idle before 
testing.

2. If the port status is idle, retry the command at 1-minute intervals up to 

5 times.

1018

ABRT

The test was disabled by administration.  Verify that the Maintenance 
Test field on the Trunk Group screen is set to n. To enable the test, use 
change trunk-group <x>, where <x> equals the number of the trunk 

group to be tested.  Change the Maintenance Test field on the screen to 

y.

1. Retry the command at 1-minute intervals up to 5 times.

 /

  

1412

ABRT

This test does not execute on a G700 media gateway.

2000

ABRT

Response to the test was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 4