Avaya 03-300430 User Manual

1000

ABRT

System resources required for this test were not available. The port may 
be busy with a valid call.

1. Use display port location to determine the trunk group/

member number of the port. Use status trunk to determine the 

service state of the port. If the port is in use, wait until it is idle before 
testing.

2. If the port status is active but the port is idle (no calls), check the error 

log for Error Type #1025. The port may be locked up.

3. If the port status is idle, retry the command at 1-minute intervals up to 

5 times.

1002

ABRT

The system could not allocate time slots for the test. The system may be 
under heavy traffic conditions, or it may have time slots out of service due 
to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic 

and the port status is idle, retry the command at 1-minute intervals up 
to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test. The system 
may be oversized for the number of Tone Detectors present, or some Tone 
Detectors may be out of service.

1. Enter list measurements tone-receiver to display information 

about the tone receivers.

2. Resolve any TTR-LEV errors.

3. Resolve any TONE-PT errors.

4. If neither condition exists, retry the command at 1-minute intervals up 

to 5 times.

1004

ABRT

The port was seized by a user for a valid call.

1. Use display port location to determine the trunk group/

member number of the port. Use status trunk to determine the 

service state of the port. If the port is in use, wait until it is idle before 
testing.

2. If the port status is idle, retry the command at 1-minute intervals up to 

5 times.

 2 of 4