Avaya 03-300430 User Manual

3 

7 

129 

131 

133 

FAIL 

Proceed as follows unless power or tone problems are suspected (see 
following note).

1. To see if the problem is on-board, disconnect the port from the far end, 

and retry the test. Coordinate this with the CO, or do it after busy 
hours.

2. If the retry fails, replace the circuit pack.

3. If the retry passes and no troubles have been reported, disable the 

test in the trunk group administration. If the retry passes and troubles 
are reported, coordinate isolation with the CO.

Note:

If the loop-around and conference circuit test fails for every 
port on a circuit pack, a -5V power problem is indicated. A 
power unit may be defective (

on page 770). If the test fails on more than 1 port, 

check for errors on the 

page 2327 or the 

page 2353 MOs.

4. Rerun the test.

PASS

DID Trunk Looparound and Conference test is successful. This port is 
functioning properly.

1. If users are reporting troubles, examine loop connections to the port 

and refer problem to the CO.

0

NO 

BOARD

The test could not relate the internal ID to the port (no board).

1. Verify that the board’s translations are correct.

2. Enter busyout board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location

This should establish the link between the internal ID and the port.

 5 of 5