Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
5-30
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 5 Repairing and Maintaining the 8112 Server
Replacing T1 Smart Blades or Smart Blades
Step 3
Press the ejector levers outward. This partially unseats the T1 Smart Blade or Smart Blade card from the
backplane connectors. See
backplane connectors. See
.
Step 4
Pull the T1 Smart Blade or Smart Blade card from the chassis by pressing the ejector levers outward and
pulling the card out. See
pulling the card out. See
Installing a new T1 Smart Blade or Smart Blade card
Step 1
Ensure that the system is powered down. If you are installing a new T1 Smart Blade or Smart Blade card
immediately after removing an old one, the system should still be powered down. Otherwise, follow the
steps in the
immediately after removing an old one, the system should still be powered down. Otherwise, follow the
steps in the
.
Step 2
Press the ejector levers outward. See
Figure 5-21 Installing a T1 Smart Blade Card and Transition Module
Step 3
Holding the T1 Smart Blade or Smart Blade card by the levers, partially insert the card into the slot,
about half way.
about half way.
Step 4
Verify that the T1 Smart Blade or Smart Blade card is properly seated in the guides, top and bottom. If
not, remove the card and try again.
not, remove the card and try again.
Step 5
Pushing gently and firmly on the T1 Smart Blade or Smart Blade card’s face plate, slide the card into the
slot until you encounter significant resistance. At this point, the levers should be in contact with the
chassis rails so they will grab when pushed inward.
slot until you encounter significant resistance. At this point, the levers should be in contact with the
chassis rails so they will grab when pushed inward.
Step 6
Use the ejector levers to seat the T1 Smart Blade or Smart Blade card in the slot by closing the levers
toward one another until they are in the horizontal locked position. See
toward one another until they are in the horizontal locked position. See
Step 7
Secure the T1 Smart Blade or Smart Blade card by tightening the captive screws at the top and bottom
of the panel. See
of the panel. See