Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
7-6
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 7 Installing a Shadow Server
Configuring the primary server
Figure 7-4
net Command Confirmation
Step 12
Confirm the settings shown here match what you have listed in
Step 13
If the settings do not match, type
n
and press Enter and repeat the necessary steps of the procedure
entering the correct data.
If the settings do match, type
y
and press Enter to commit to and save the changes. The last five lines
of
appear.
Step 14
Type
99
and press Enter to exit the “net” utility.
Using MeetingTime to attach the shadow server
Follow these steps to attach the shadow server.
Step 1
Using MeetingTime, log into the primary server.
Step 2
Go to the
Configure
tab and select
Usage Parameters
from the left pane.
Step 3
Click
Query
. Values appear in the right pane.
Step 4
Scroll to the
Network Shadow Svr
section about half way down.
Step 5
Change the value for
Shadow attached?
from “No” to “Yes”.
Step 6
Click
Save Changes
in the bottom right corner.
Step 7
Log out and close MeetingTime.
Select: 99
Current server configuration:
Unit: #9 (vp9)
Active: YES
Description: Shadow Server
Kind: Shadow server
IP Address: 10.10.10.10
Ethernet address: 0001bc0211b8
Site: #0 (Home Site)
Site subnet mask: 255.255.255.0
Site broadcast addr: 0.0.0.0
Site default gateway: 10.10.10.1
Route daemon: disabled
Do you wish to commit these changes (y/n)? y
1) View the server & site configuration
2) Modify the server configuration
3) Select another server (current unit = #9)
99) Quit
Select: 99