Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-59
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Figure 4-63 Completing IP Port Configuration
Step 8
Type the correct slot number for the blade you want to modify and press Enter. In this example, it is slot
6 so type 6 and press Enter.
6 so type 6 and press Enter.
Step 9
Continue pressing Enter until you are prompted to enter the IP address, as shown in line 15 of
Step 10
Type the correct IP address and press Enter.
Step 11
Continue pressing Enter and verify the default settings are correct for this installation. If your
installation calls for values other than the defaults, make the necessary changes, and continue pressing
Enter until you see the “blade” command menu.
installation calls for values other than the defaults, make the necessary changes, and continue pressing
Enter until you see the “blade” command menu.
Step 12
Verify that the IP address was changed correctly by typing
1
and pressing Enter to view the blade details.
When prompted, type the slot number for the blade you want to see.
Step 13
If it is correct, type
x
and press Enter to exit the program. If not, repeat the steps above.
***** B L A D E C O N F I G M E N U *****
1) View blade details
2) Modify blade
x) Exit program
Enter command: 2
Enter blade slot [1..6]: 6
Type [IP]:
Card Type [TP1610-4]:
Port Group [ 3]:
Number of Ports [120]:
1st Port [ 23]:
IP address [0] [0.0.0.0]: 10.10.10.10
IP address [1] [0.0.0.0]: 10.10.10.11
Subnet Mask [0.0.0.0]: 255.255.255.0
Default Gateway [0.0.0.0]: 10.10.10.1
Base UDP Port [0] [ 5000]:
Jitter Buffer Minimum Size [ 100]:
Jitter Buffer Optimization [ 7]:
IP Precedence [0]:
Type of Service (TOS) [ 0]:
DSCP / DiffServ [unused]:
RTCP Interval [default]: