Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-58
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Step 1
If you do not already have terminal logging turned on, turn it on before proceeding. For information on
logging, see the
logging, see the
Step 2
At the tech$ prompt, type
blade -i <number of IP ports>
and press Enter. This is the command for a
pure IP system.
Step 3
Confirm the “blade” command you entered and type
y
and press Enter. If you entered the wrong
command, type
n
and press Enter and then re-enter the correct command.
The system tells you what it is configuring. The tech$ prompt appears when configuration is complete.
See
See
.
Figure 4-62
blade Command — IP
Step 4
Verify your configuration by typing
blade
and pressing Enter.
Step 5
Confirm the screen output is correct for your configuration.
Step 6
Type
x
and press Enter to exit the “blade” command utility.
Caution
Before using the “blade” command to configure an IP system, you must understand the assumptions in
. If your installation does not match these assumptions, you must customize the configuration
by using the “blade” command’s second option that allows you to modify the blade.
Step 7
Type
2
and press Enter to modify the blade. A prompt for the blade slot to modify appears, as shown in
meetingplace:tech$ blade -i <# IP ports>
This will reset many DB tables, are you sure? (y/n): y
Configuring “X” IP ports
Restart the system for changes to take effect
meetingplace:tech$
Table 4-12 blade Command Assumptions for IP Systems
Number of IP Ports
Assumed Multi-Access Blade Type
1-120
1 MA-4
121-240
2 MA-4
241-480
1 MA-16