Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-60
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Example of a pure IP configuration
This section explains how to use the “blade” command when configuring 480 IP ports.
Step 1
If you do not already have terminal logging turned on, turn it on before proceeding. For information on
logging, see the
logging, see the
Step 2
At the tech$ prompt, type
blade -i 480
and press Enter.
Step 3
Confirm the “blade” command you entered and type
y
and press Enter. If you entered the wrong
command, type
n
and press Enter, then re-enter the correct command.
The server responds by telling you how many ports it is configuring. When the tech$ prompt appears, it
is complete. See
is complete. See
.
Figure 4-64 blade Example for 480 IP Ports
Step 4
Verify your configuration by typing
blade
and pressing Enter.
Step 5
.
Figure 4-65 blade Confirmation for 480 IP Ports
Step 6
Type
2
and press Enter to modify a blade. A prompt for the blade slot to modify appears, as shown in
meetingplace:tech$ blade -i 480
This will reset many DB tables, are you sure? (y/n): y
Configuring 480 IP ports
Restart the system for changes to take effect
meetingplace:tech$
meetingplace:tech$ blade
Slot Card Type CardId Ports
---- ---- ---- ------ -----
1 CG6000C SB 0
2 CG6000C SB 1
3 CG6000C SB 2
4 CG6000C SB 3
5 CG6000C SB 4
6 CG6000C IP 0 0-479 (No IP address)
***** B L A D E C O N F I G M E N U *****
1) View blade details
2) Modify blade
x) Exit program