Cisco Cisco TelePresence Management Suite (TMS) Version 15
2. Shut down Cisco Telepresence Manager completely.
3. Remove Cisco TelePresence Manager from the network or disable its network connection.
Task 33: Completing the dial plan changes
Complete any remaining changes to dial plan in Unified CM that were deferred during staging.
Task 34: Reenabling services and management (new Cisco
TMS)
TMS)
If working with a new Cisco TMS installation where you have already done a trial import and services have
since been disabled:
since been disabled:
1. Re-enable all Cisco TMS Windows services.
2. In Cisco TMS, set
Administrative tools > Configuration > Network settings > TMS Services
>
Enforce Management Settings on Systems to Yes.
Task 35: Adding bridges to Cisco TMS
If you are deploying new TelePresence Servers or need to do any reconfiguration of existing servers such as
clustering or cluster expansion, complete this before adding the bridges to Cisco TMS.
clustering or cluster expansion, complete this before adding the bridges to Cisco TMS.
Follow the instructions in TelePresence Server documentation on installation and configuration:
n
n
Next, add all of your TelePresence Servers into Cisco TMS using the information collected during planning,
following the instructions in the Cisco TMS webhelp or administrator guide. For SIP-trunked bridges, make
sure to disable:
following the instructions in the Cisco TMS webhelp or administrator guide. For SIP-trunked bridges, make
sure to disable:
n
H.323 dialing (incoming and outgoing)
n
IP address dialing (incoming and outgoing)
When you have added the bridge, configure the numeric ID settings for each TelePresence Server:
1. In Cisco TMS
Systems > Navigator
, select the TelePresence Server and go to
Settings > Extended
Settings
, then configure Numeric ID Base, Numeric ID Step, and Numeric ID Quantity to match your
dial plan. These settings control the numeric addresses that Cisco TMS will use when scheduling calls on
that bridge.
Ensure that there is a minimum of 1-2 numeric IDs available per bookable port.
that bridge.
Ensure that there is a minimum of 1-2 numeric IDs available per bookable port.
Replacing Cisco TelePresence Manager with Cisco TMS and Cisco TMSXE Deployment Guide (14.5 and
4.1)
4.1)
Page 37 of 51
Cutover (downtime)