Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
If you opt not to follow this recommendation, you must go to the system's
Settings > Edit Settings
tab in Navigator once
the system has been added and click Enforce Management Settings, repeating this on-demand enforcement whenever
settings change or need to be reset from Cisco TMS.
settings change or need to be reset from Cisco TMS.
Note that if you add one or more systems to a second Cisco TMS instance in a test environment, you must only leave
Enforce Management Settings on Systems in one Cisco TMS instance to avoid conflict.
Enforce Management Settings on Systems in one Cisco TMS instance to avoid conflict.
Using Automatic Discovery
To enable automatic system discovery:
1.
Go to
Administrative Tools > Configuration > Network Settings
.
2.
Set Automatic System Discovery Mode to
On and verify that Default Folder for Discovered Systems is set to an
appropriate folder.
3.
Click Save.
If you want to receive notifications by email each time a new system is discovered and added:
1.
Go to
Administrative Tools > Configuration > Network Settings
.
2.
In the Event Notification section, add your address to E-mail Addresses to Receive System and Network
Notifications.
Notifications.
As systems on the network send HTTP events or are detected by the SNMP scanner service, they will now be added to
the specified folder, and you will be notified.
the specified folder, and you will be notified.
To review the settings of these systems:
1.
Go to
Systems > Navigator > [Name of your folder for discovered systems]
.
The default folder is Discovered Systems.
2.
Review and adjust the settings for each system as desired.
3.
Verify on the system's Permissions tab that new user groups will have permissions for the system. Modify as
required.
required.
4.
If desired, move the systems to a more permanent folder by selecting the system and clicking Move/Copy in the
folder listing.
folder listing.
Adding by IP addresses or DNS Names
All types of infrastructure systems and endpoints can be added following the steps below. Note however that endpoints
registered to Unified CM must not be added in this way, see
registered to Unified CM must not be added in this way, see
.
To add a system:
1.
Go to
Systems > Navigator
.
2.
Open Discovered Systems to verify that the system you are planning to add has not been added automatically by
Cisco TMS already.
Cisco TMS already.
—
—
If the system is not in the Discovered Systems folder, select the folder to which you want to add the system.
45
Cisco TelePresence Management Suite Administrator Guide
Adding and Managing Systems