Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
3.
Click Add Systems.
4.
Enter either the IP address, the DNS name, an IP range, or a comma-separated list of IP addresses and/or
DNS names.
DNS names.
Note that adding very large ranges slows down the system discovery scan process.
5.
Select ISDN Zone, IP Zone and Time Zone for the system from the drop-down lists.
6.
Click the
Advanced Settings
section heading to expand it to add authentication details, configuration template, or
SNMP discovery options.
.
7.
Click Next to start adding the system.
A progress window will be shown as Cisco TMS connects to the address and determines the type of system being
added, and the system's configuration.
added, and the system's configuration.
8.
You will now be prompted if a password is needed to access the system. Enter the password and click Next.
A Results page is shown with a status for each system Cisco TMS tried to add. If Cisco TMS detected problems
with any system's configuration, a message in the Description column states that the system has not yet been
added.
with any system's configuration, a message in the Description column states that the system has not yet been
added.
—
To address errors immediately, click Edit System. Use the displayed information to make the necessary
adjustments, then click Save.
adjustments, then click Save.
If the problem is resolved, the settings page will close and you will be returned to the Results page, which
has been updated to state that the system was successfully added.
has been updated to state that the system was successfully added.
—
To address the error(s) later or ignore them altogether, click Add System Despite Warnings on the Settings
or Results page.
or Results page.
—
When adding a TelePresence Server you will get an error stating that it is in remotely managed mode—ignore
this.
this.
9.
Click Finish Adding Systems to return to the main
Navigator
view.
Your new system will now be in the designated folder.
System Discovery Order by Protocol
When adding systems, Cisco TMS attempts to connect to them using SNMP first, trying all the community names defined
in
in
Administrative Tools > Configuration > Network Settings >
SNMP Community Name. Cisco TMS tries connecting
over SNMP for the period of time defined in
Network Settings >
SNMP Timeout.
46
Cisco TelePresence Management Suite Administrator Guide
Adding and Managing Systems