Cisco Cisco Fiber IGESM Switch Module for IBM Release Notes

The CONFIG_FILE environment variable can also be reset by using the no boot config-file 
global configuration command.

The HELPER_CONFIG_FILE environment variable can also be reset by using the no boot 
helper-config-file global configuration command.

These commands were added to the command reference:

Use the platform chassis-management protected-mode global configuration command to enable 
protected mode on the CIGESM blade switch. Use the no form of this command to return to the default 
setting.

This command has no arguments or keywords.

Protected mode is turned off.

Global configuration

By default, the IBM management module controls the blade switch. When you enter this command, 
control of the blade switch by the management module is disabled. 

Protected mode must be enabled on the chassis management module before you enter this command on 
the blade switch. For information about enabling protected mode on the chassis management module, 
see the management module documentation at this URL:

http://www-03.ibm.com/servers/eserver/support/bladecenter/index.html

You must reboot the blade switch after entering the command. 

The switch blocks this command if, after rebooting, an IP-manageable interface on the switch module is 
not reachable from an external interface. (This prevents the switch module from being unmanageable 
after reboot.)

12.1(22)EA9

This command was introduced.