Cisco Headend System Release 2.5 Installation Guide
Add an SCS
4017650 Rev C
57
CAUTION:
If you need to make changes to the SCS modeling parameters, such as
changing the IP address, all sources on the device should be stopped to allow
the change to be made.
If you need to make changes to the SCS modeling parameters, such as
changing the IP address, all sources on the device should be stopped to allow
the change to be made.
1 On the DNCS Administrative Console, click the DNCS tab, and then click the
Network Element Provisioning tab.
2 Click SCS. The SCS Devices window opens.
3 Select an SCS and click Open Selected SCS. The Update SCS Device window
3 Select an SCS and click Open Selected SCS. The Update SCS Device window
opens.
4 Make the desired changes. If you need help completing any fields, refer to the
procedure for Setting Up SCS Modeling Parameters (on page 55).
5 When you finish making changes, click Update. The system saves this
information into the DNCS database.
6 Change your network map to reflect these changes.
7 Click Exit. Your next step is to set up the connections between the SCS and its
7 Click Exit. Your next step is to set up the connections between the SCS and its
associated MPEG source. Go to Setting Up SCS Connections (on page 60).
Deleting the SCS
After you have created and saved an SCS, you are allowed to delete any SCS. Make
sure you tear down the session on the SCS, then delete the ports on the SCS before
proceeding further, refer to Deleting SCS Ports Modeling Parameters (on page 60).
sure you tear down the session on the SCS, then delete the ports on the SCS before
proceeding further, refer to Deleting SCS Ports Modeling Parameters (on page 60).
Note: For detailed procedures for tearing down sessions, refer to the Online Help
for SR i4.2.2.
1 On the DNCS Administrative Console, click the DNCS tab, and then click the
for SR i4.2.2.
1 On the DNCS Administrative Console, click the DNCS tab, and then click the
Network Element Provisioning tab.