Cisco Headend System Release 2.5 Installation Guide
Add an SCS
4017650 Rev C
55
Symbol Rate of the channel being used to send data from the SCS to the hubs on
your system
your system
Number identifying the input port on this SCS that is logically connected to the
associated MPEG source
associated MPEG source
Note: All this information should be recorded for setting up the SCS. However, if it
is not, contact your system administrator to obtain the information.
is not, contact your system administrator to obtain the information.
Process Overview
Be sure to allow yourself adequate time to complete this procedure. Adding an SCS
takes approximately 30 minutes. To add an SCS to the DNCS, you must complete the
following procedures:
takes approximately 30 minutes. To add an SCS to the DNCS, you must complete the
following procedures:
Setting Up SCS Modeling Parameters (on page 55)
Setting Up SCS Ports Modeling Parameters (on page 58)
Setting Up SCS Connections (on page 60)
Setting Up SCS Modeling Parameters
1 On the DNCS Administrative Console, click the DNCS tab, and then click the
Network Element Provisioning tab.
2 Click SCS. The SCS Devices window opens.