ONKYO PR-RZ5100 Owner's Manual

|

on the radio wave.

•  When other wireless LAN devices are used near the 

unit, several issues such as interrupted playback 

and communication may occur. You can avoid these 

issues by changing the channel of your wireless LAN 

router. For instructions on changing channels, see the 

instruction manual provided with your wireless LAN 

router.

•  There may not be enough bandwidth available in 

wireless LAN. Connect using an Ethernet cable.

■ Cannot ZONE output audio of external AV 

•  Depending on the model, input by HDMI cable may 

not be supported. Check in "Multi-zone Connection" 

in the Basic Manual, and if input by HDMI cable is not 

supported, connect using a cable that is supported.

•  The audio from externally connected AV components 

can only be output when the audio is analog or 2ch 

PCM audio signals. If you have connected the AV 

component to this unit with a digital optical/coaxial 

cable, the audio output of the AV component needs to 

be set to PCM.

■ Others

•  Settings are required in Initial Setup, "Multi Zone Setup" 

to use the multi-zone feature. Check in "Initial Setup" in 

the Basic Manual.

•  If the audio signal is from the NET input selector, zone 

output is not possible for DSD and Dolby TrueHD audio 

signals.

•  Make sure that the batteries are installed with the 

correct polarity.

•  Install new batteries. Do not mix different types of 

batteries, or old and new batteries.

•  Make sure that the unit is not subjected to direct 

sunshine or inverter-type fluorescent lights. Relocate if 

necessary.

•  If the unit is installed in a rack or cabinet with colored-

glass doors or if the doors are closed, the remote 

controller may not work reliably.

•  After operating the Multi-zone function (for compatible 

models only), the remote controller may have switched 

to the mode for operating ZONE output audio. Check 

"Multi-zone" in "Playback" in the Basic Manual to switch 

the remote controller back to the mode for operating in 

the main room.

■ The display doesn't light

•  The display may go dim while the Dimmer is working, 

and may also turn off (for compatible models only). 

Press DIMMER button and change the brightness level 

of the display.

•  The display is turned off when the Pure Audio (for 

compatible models only) listening mode is selected.

■ Strange noises can be heard from the unit

•  If you have connected another unit to the same wall 

outlet as this unit, this noise may be an effect from the 

other unit. If the symptoms improve by unplugging the 

power cord of the other unit, use different wall outlets for 

this unit and the other unit.

■ When performing AccuEQ Room Calibration, the 

•  This can be caused by a malfunction in your speaker 

unit. Check if the unit produces normal sounds.