Digital Monitoring Products Inc PC0096 User Manual

The XT30/XT50 Cellular option is available built-in at the factory or as an optional add-on module, Model

263G. The J19 SMA cellular antenna connector is provided for the built-in cellular version and protrudes

through the top of the enclosure.
If the panel is not purchased with built-in cellular, then the J24 header is provided to connect a 263G Digital

Cellular Communicator as an add-on. The 263G Digital Cellular Communicator provides a cellular antenna

connection that protrudes through the top of the enclosure similar to J19.

 

              

The XT50 Wireless Antenna terminal block J20 is located at the top right corner of the circuit board. The

antenna installs through a small opening in the top of the enclosure and is attached to the panel using the 

right terminal. The left terminal is not used.
The XT50 built-in wireless operates with DMP 1100 Series transmitters. See section 3.4 for a list of accessory

devices.  

Two LEDs display receiver operation and activity. Refer to the table below as required.

Green LED - Flashes to indicate data is being transmitted from the receiver.
Yellow LED - Flashes to indicate data is being received from a transmitter.

Outputs

J11

1 

2 

3 

4

J1

Ethernet

J16

Reset

J20

1100 Series

Wireless 

Antenna 

connection

J24 Celllular 

header for 

263G 

connection

J19 Celllular 

Antenna 

connector

65555

Built-in Cellular 

Module

Connect 

antenna to 

right side 

only

J18

Load

RED

Programming

J8

1100 Series

Antenna

(XT50)

Model 383

supplied 

with panel