Cisco Cisco ONS 15454 M12 Multiservice Transport Platform (MSTP) Guía De Instalación

The XC-XVC-10G card has the following specifications:

Environmental

Operating temperature: 

I-Temp (15454-XC-VXC-10G-T): –40 to 149 degrees Fahrenheit (–40 to +65 degrees Celsius)

Operating humidity: 5 to 85 percent, noncondensing

Power consumption: 60 W, 1.25 A, 204.73 BTU/hr

Dimensions

Height: 12.650 in. (321.3 mm)

Width: 0.716 in. (18.2 mm)

Depth: 9.000 in. (228.6 mm)

Card weight: 1.5 lb (0.6 kg)

For compliance information, refer to the Cisco Optical Transport Products Safety and Compliance 
Information.

Use this section if you are installing the XC-VXC-10G cards for the first time. After you become familiar 
with ONS 15454 card installation and boot up, use this section as a reference. 

Always use the supplied electrostatic discharge (ESD) wristband when working with a powered ONS 
15454. Plug the wristband cable into the ESD jack located on the lower right outside edge of the shelf 
assembly and ensure the shelf assembly is properly grounded.

Because all other cards boot from the active TCC2/TCC2P card, at least one TCC2/TCC2P card must be 
installed in order to boot the XC-VXC-10G cards. Cisco strongly recommends that you always install 
and boot two TCC2/TCC2P cards before running any live traffic over an ONS 15454 node.

If protective clips are installed on the backplane connectors of the cards, remove the clips before 
installing the cards.

XC-VXC-10G cards have electrical plugs that plug into electrical connectors on the shelf assembly 
backplane. When the ejectors are fully closed, the card plugs into the shelf assembly backplane. 

 shows general card installation.