Schneider Electric PM5300 Manual De Usuario

38

© 2014 Schneider Electric All Rights Reserved

Chapter 4—Front panel display and meter setup

PowerLogic™  PM5300 series user guide

7. Press   to exit. Press Yes to save your changes.

The HMI (human-machine interface) setup screens allow you to:

•

control the general appearance and behavior of the display screens,

•

change the regional settings, or

•

change the meter passwords.

You can change the display screen’s contrast or the screen backlight and timeout 
settings.

1. Navigate to Maint > Setup.

2. Enter the setup password (default is “0000”), then press OK.

3. Navigate to HMI > Displ.

4. Move the cursor to point to the parameter you want to modify, then press Edit.

5. Modify the parameter as required, then press OK.

6. Move the cursor to point to the next parameter you want to modify, press Edit, 

make your changes, then press OK.

IP Address

Contact your local 
network administrator 
for parameter values.

The internet protocol address of your device.

Subnet

The Ethernet IP subnetwork address of your 
network (subnet mask).

Gateway

The Ethernet IP gatway address of your network.

HTTP Server

Disabled

Controls whether your device’s webserver and 
webpages are active or not.

Device Name

N/A

This parameter is read-only for reference purposes.

IP Method

DHCP, BOOTP, 
Stored, Default

This controls the network protocol for your device 
(what the meter uses to obtain its IP address).
•

DHCP: Dynamic Host Configuration Protocol

•

BOOTP: Bootstrap Protocol

•

Stored: Use the static value programmed in the 
IP Address setup register

•

Default: Use 85.16 as the first two values of the 
IP address, then convert the last two 
hexadecimal values of the MAC address to 
decimal and use this as the last two values of 
the IP address.
Example: MAC address = 00:80:67:82:B8:C8
Default IP = 85.16.184.200

Maint

Reset

Meter

Comm

Alarm

I/O

Clock

Region

Pass

Displ

Setup

HMI