3com S7906E Guide De Référence

 

1-36 

By default, IPv6 PIM-SM is disabled.  

Note that this command can take effect only after IPv6 multicast routing is enabled on the device. 

Related commands: pim ipv6 dm;  multicast ipv6 routing-table in the IPv6 Multicast Routing and 

Forwarding Commands in the IP Multicast Volume. 

# Enable IPv6 multicast routing, and enable IPv6 PIM-SM on VLAN-interface 100.  

<Sysname> system-view 

[Sysname] multicast ipv6 routing-enable 

[Sysname] interface vlan-interface 100 

[Sysname-Vlan-interface100] pim ipv6 sm 

Interface view 

2: System level 

None 

Use the pim ipv6 state-refresh-capable command to enable the state fresh feature on the interface. 

Use the undo pim ipv6 state-refresh-capable command to disable the state fresh feature.  

By default, the state refresh feature is enabled. 

Related commands: state-refresh-interval, state-refresh-rate-limit, state-refresh-hoplimit. 

# Disable state refresh on VLAN-interface 100. 

<Sysname> system-view 

[Sysname] interface vlan-interface 100 

[Sysname-Vlan-interface100] undo pim ipv6 state-refresh-capable 

pim ipv6 timer graft-retry interval