3com S7906E Guide De Référence
2-12
radius nas-ip
Syntax
radius nas-ip ip-address
undo radius nas-ip
View
System view
Default Level
2: System level
Parameters
ip-address: IP address in dotted decimal notation. It must be an address of the device and cannot be all
0s address, all 1s address, a class D address, a class E address or a loopback address.
Description
Use the radius nas-ip command to set the IP address for the device to use as the source address of
the RADIUS packets to be sent to the server.
Use the undo radius nas-ip command to remove the configuration.
By default, the source IP address of a packet sent to the server is the IP address of the outbound port.
Note that:
z
Specifying a source address for the RADIUS packets to be sent to the server can avoid the
situation where the packets sent back by the RADIUS server cannot reach the device as the result
of a physical interface failure.
z
If you configure the command for more than one time, the last configuration takes effect.
z
The nas-ip command in RADIUS scheme view is only for the current RADIUS scheme, while the
radius nas-ip command in system view is for all RADIUS schemes. However, the nas-ip
command in RADIUS scheme view overwrites the configuration of the radius nas-ip command.
Related commands: nas-ip.
Examples
# Set the IP address for the device to use as the source address of the RADIUS packets to 129.10.10.1.
<Sysname> system-view
[Sysname] radius nas-ip 129.10.10.1
radius scheme
Syntax
radius scheme radius-scheme-name
undo radius scheme radius-scheme-name
View
System view