3com S7906E Guide De Référence

 

1-15 

<Sysname> system-view 

[Sysname] rip 100 

[Sysname-rip-1] output-delay 30 count 10 

peer ip-address 

undo peer ip-address 

RIP view 

2: System level 

ip-address: IP address of a RIP neighbor, in dotted decimal format.  

Use the peer command to specify the IP address of a neighbor in the non-broadcast multi-access 

(NBMA) network, where routing updates destined for the peer are unicast, rather than multicast or 

broadcast. 

Use the undo peer command to remove the IP address of a neighbor. 

By default, no neighbor is specified. 

Note that you need not use the peer ip-address command when the neighbor is directly connected; 

otherwise the neighbor may receive both the unicast and multicast (or broadcast) of the same routing 

information. 

# Specify to send unicast updates to peer 202.38.165.1. 

<Sysname> system-view 

[Sysname] rip 1 

[Sysname-rip-1] peer 202.38.165.1 

preference [ route-policy route-policy-name ] value 

undo preference [ route-policy ] 

RIP view 

2: System level