Lucent Technologies P332MF Manuale Utente

Chapter 6

Cajun Campus CLI – Layer 2

80

Cajun P332MF User’s Guide

Use the

 set inband vlan command to set a value for the management vlan 

(from 1 to 3071).

The syntax for this command is:
set inband vlan <value>

Example:
Cajun_P330-N# set inband vlan 1
Management VLAN number set to 1

Use the

 set flowcontrol command to set the send/receive mode for flow-

control frames (IEEE 802.3x or Lucent proprietary) for a full duplex port. Each 
direction (send or receive) can be configured separately only for Gigabit ports. 
Lucent proprietary flow control cannot be configured on Gigabit ports. The

 set 

flowcontrol command cannot be used on Gigabit ports for which 
autonegotiation is enabled.

The syntax for this command is:
set flowcontrol {receive|send|all} <mod_num>/<port_num> 
{on|off|proprietary}

value

A VLAN number between 1 and 3071.

receive

Controls the receipt of IEEE802.3x flow-control frames on Gigabit 
ports only:
• ON indicates that the local port will act upon flow control frames 

received from the far end

• OFF indicates that the local port will discard flow control frames 

received from the far end

send

Controls the sending of IEEE802.3x flow-control frames from Gigabit 
ports only:
• ON indicates that the local port is allowed to send flow control 

frames to the far end

• OFF indicates that the local port is not allowed to send flow control 

frames to the far end