HP designjet l65500 Manuale

Select Carriage beam position > Move to printing (normal) from the front panel's Substrate
menu 

 to lower the carriage beam into its normal position, close to the substrate. This process

takes about two minutes to complete.

Replace the carriage oiler foams (see 

). While

replacing the foams, also replace both of the oil wicks.

Clean the outside of the printer and all other parts of the printer that you regularly touch as part of normal
operation with a damp sponge or a soft cloth and a mild household cleaner such as non-abrasive liquid
soap.

To avoid an electric shock, make sure that the printer is turned off and unplugged before

you clean it. Do not let water get inside the printer.

Do not use abrasive cleaners on the printer.

There are three ink deposits, one for each printhead. They may need to be cleaned every three or four
months, depending on your use of the printer. An alert is displayed when the ink deposits are 85% full,
and again when they are full and need to be cleaned.

Go to the front panel and select Clean ink deposits from the Preventive Maintenance menu

.

Wait until the printhead carriage has stopped moving, then open the printhead access door in the
side of the printer.

ENWW

Clean the exterior of the printer

15