Honeywell International Inc. SF61B-A Manuale Utente

You scan a bar code, the 
SF61B beeps twice, and 
the status light blinks 
green twice, but the data 
is not transmitted to the 
host computer.

Try these possible solutions:

Make sure that your data collection application 
is set up to receive data from the SF61B.

If you are using an SD61 Base Station 
connected to your host using an RS-232 cable, 
make sure that the serial parameters on the 
SD61 match the serial parameters of the host 
computer. The default serial parameters for the 
SD61 are 19200 baud, 8 data bits, no parity, 
and 1 stop bit.

You scan a 
configuration bar code 
and the SF61B emits six 
very fast beeps. 

The SF61B does not recognize or support the 
configuration bar code you scanned.

You scan a bar code and 
the status light turns 
on, but the SF61B does 
not beep.

The beep duration, volume, frequency, and 
number may be deactivated: 

use EasySet to check your product’s settings 
(see 

 in Chapter 3, 

) and 

reconfigure your product if required

You cannot establish a 
Bluetooth connection 
with your scanner.

There may be a problem with your host Bluetooth 
interface, try one or more of the following:

disable then enable your host Bluetooth radio 
from the 

Device Manager (Windows host) or 

equivalent for your host device

disconnect then reconnect your Bluetooth 
adapter if applicable

force a restart of your SF61B (hardware reset), 
see 

chapter)

re-pair your scanner with your host device / 
application (see the appropriate section in 
Chapter 2, 

)

your scanner may be connecting with / 
connected to another Bluetooth host, 
disconnect the other Bluetooth connection if 
required (see Chapter 2, 

Problem

Possible Solution