Zhone 2000 ユーザーズマニュアル

- 48 -

 

This chapter describes how to configure the IAD WAN interface and 
datalink protocol for data operation.

‹

Basic WAN setup tasks (page

)

‹

Using the WAN Configuration menu (page

‹

Selecting the Datalink Protocol (page

‹

Selecting the Physical Interface (page

‹

Configuring the G.SHDSL Interface (page

‹

Configuring the SDSL Interface (page

)

‹

Configuring the ADSL Interface (page

)

‹

Setting the Interface to T1 or E1 (page

‹

Configuring the T1 Interface (page

)

‹

Configuring the E1 Interface (page

)

‹

Configuring ATM PVCs (page

‹

Configuring ATM Options (page

‹

Configuring Frame Relay DLCIs (page

‹

Configuring Frame Relay Options (page

)

‹

Using the Quick Configure Option (page

To set up the IAD for voice and data operation, you must perform at least 
these basic tasks:

‹

Select ATM or Frame Relay as the datalink protocol (page

‹

For ATM protocol, configure ATM PVCs (page

) and ATM options 

(page

)

‹

For Frame Relay protocol, configure Frame Relay DLCIs (page

and Configure Frame Relay options (page

‹

Configure the WAN interface for your IAD (following)

‹

For channelized T1, set up voice and data circuits (page

‹

Configure the voice path (

Use the flowcharts below to plan your tasks for configuring either xDSL or 
T1/E1 based on your wide area networking requirements.

 

When the IAD prompts you for input, it displays the default or 
current value in parentheses. To conveniently accept this 
value, just press Enter.