Generac Power Systems H-100 사용자 설명서

Each line displays a maintenance item that has 
been set up via GenLink. The value displayed is the 
approximate % of life remaining before maintenance 
should be performed. Refer to the Maintenance setup 
using GenLink.

Press the “ENTER” button.

This is a typical third Maintenance Status page. Each 
line displays a maintenance item that has been set 
up via GenLink. The value displayed is the approxi-
mate % of life remaining before maintenance should 
be performed. Refer to the Maintenance setup using 
GenLink.

Press the “ENTER” button.

This is a typical fourth Maintenance Status page. The 
first line is the display contrast. The display contrast 
is able to be changed on this page. However, changing 
this setting can result in the display becoming non-
readable. Use caution. Use the arrow buttons to go to 
the contrast field. Press the “ENTER” button to enter 
edit mode. Use the arrow buttons to change the con-
trast value (range is 00 to 37). Pressing the “HOME” 
button while in edit mode will return the value to the 
last entered value. Press the “ENTER” button to exit 
edit mode. 

There are three Generator Parameter pages – voltage 
parameters, power parameters, and i2t parameters.

Do the following to view the generator parameter 
pages:

Press the “MENU” button.

Press the 

 button and then the  button.

Press the “ENTER” button.

This is a typical first Generator Parameter page for a 
three phase system.

LINE 1:  Phase titles for the voltage and current.

LINE 2:  Line-to-Line voltages in Volts RMS.

LINE 3:  Line currents in Amps RMS.

LINE 4:  Generator frequency in Hz followed by the 
“More” field to allow page selection.

The voltages can be converted to values representing 
the line-to-neutral voltages by changing the title line 
(first line) using edit mode. Use the arrow buttons 
to move to one of the title fields – A-B, B-C, or C-A. 
Press the “ENTER” button to enter edit mode. Use 
the up or down arrow button to change the display to 
A-N, B-N, and C-N. Press the “ENTER” button to exit 
edit mode. The same process is followed to return to 
line-to-line displays. This also affects the left display 
voltage page.

 18