Tyco Safety Products/Sensormatic AMB9020 Manual Do Utilizador
Preliminary 2003-11-21
DUAL ANTENNA SCANMAX PRO DEACTIVATOR CONTROLLER
8200-0365-01, REV. 1A
INSTALLATION AND SERVICE GUIDE
6 of 12
Basic Setup
Figure 1. Controller control panel
Note: This procedure is used for Antenna 1 and
Antenna 2. If only one antenna is used, it MUST be
plugged into the Antenna 1 port for the unit to
function properly.
Antenna 2. If only one antenna is used, it MUST be
plugged into the Antenna 1 port for the unit to
function properly.
Referring to Figure 1:
1. If used, plug either the indicator board cable
(PowerPad Pro antenna only) and/or the
remote alarm cable into the REMOTE port of
the controller. A Y-adapter is required if using
both devices.
remote alarm cable into the REMOTE port of
the controller. A Y-adapter is required if using
both devices.
2. Plug each antenna cable into one of the two
ANTENNA ports on the controller. If using only
one antenna, use only Antenna Port 1.
one antenna, use only Antenna Port 1.
IMPORTANT!
If two antennas are used and
one is an IS Pro antenna and one is not, the IS
Pro antenna MUST be plugged into the
Antenna 1 port or the unit will not function
properly.
Plug the dc power supply cord into the
controller. Do not plug the dc supply into the ac
outlet yet.
Pro antenna MUST be plugged into the
Antenna 1 port or the unit will not function
properly.
Plug the dc power supply cord into the
controller. Do not plug the dc supply into the ac
outlet yet.
WARNING!
Do not plug or unplug
ANY controller cables with power on.
WARNING—
RISK OF ELECTRIC SHOCK!
RISK OF ELECTRIC SHOCK!
Keep the power cord and antenna
cable away from cash drawers and
other items whose operation may
pinch or otherwise damage them.
Failure to do so can damage
equipment or injure people nearby.
cable away from cash drawers and
other items whose operation may
pinch or otherwise damage them.
Failure to do so can damage
equipment or injure people nearby.
3. Plug the power supply into an ac outlet. The
status indicator may blink orange while the
controller auto-synchronizes. Once synchro-
nization is complete, this indicator should turn
solid green. Auto-synchronization can take up
to ten seconds.
Note: If the status indicator is blinking green,
either the deactivation or transmit function is
disabled. If the indicator is alternating
red/yellow or is solid red, then there is no high
voltage available for deactivation. For either
case, contact the Customer Response Center.
The complete list of status indications is shown
on page 7.
controller auto-synchronizes. Once synchro-
nization is complete, this indicator should turn
solid green. Auto-synchronization can take up
to ten seconds.
Note: If the status indicator is blinking green,
either the deactivation or transmit function is
disabled. If the indicator is alternating
red/yellow or is solid red, then there is no high
voltage available for deactivation. For either
case, contact the Customer Response Center.
The complete list of status indications is shown
on page 7.
4. Verify operation by swiping a deactivateable
label across the antenna and passing it
through the EAS system at the exit.
through the EAS system at the exit.
!
Port 2 Antenna
Ports 1 and 2
Scan I/O Ports 1 and 2
Power Button
RS485 Ethernet
Mode Indicators
Service
Port 1
Port 1
POS Port
Remote Ports 1 and 2