Краткое Руководство По Установке для Ricoh ap204
NetWare Configuration
32
3
Reference
C
Click
[Property Sheet]
and click
[OK]
.
The Browse dialog of the Network Interface Board appears.
D
Click
[IPX network board]
.
E
F
Select the name of the Network Interface Board which is to be configured
by clicking it, and click
by clicking it, and click
[Next >]
.
Note
❒ If you don't know which Network Interface Board you are configuring,
print the Configuration Page using the printer's operation panel, and select
the MAC address that is on the page.
the MAC address that is on the page.
G
Confirm that the MAC and IPX addresses are correct, and click
[Finish]
.
[NIB Setup Tool]
window appears.
H
Click
[Configure]
.
The property sheet appears.
I
Click the
[NetWare]
tab, and make the following settings.
A In the
[Print Server Name]
box, input the name of the print server.
B In the
[File Server Name]
box, input the name of the file server in which a
print server is to be created.
Clicking
Clicking
[Browse]
, you can select a file server among those listed in the
Browse dialog.
C In the
[Print server Operation mode]
group, click
[As Remote Printer]
.
D In the
[Remote Printer No.]
box, input the printer number.
Important
❒ Use the same printer number as that to be created in the printer server.
E Click
[OK]
to close the property sheet.
F After the message appears to confirm the reboot, click
[Yes]
.
J
In the
[NIB]
menu, click
[Exit]
to exit the NIB Setup Tool.
K
Input “PCONSOLE” from the command prompt.
F:> PCONSOLE
L
Create a print queue as follows.