Технические ссылки для Cisco Cisco 4100 Series Wireless LAN Controller

 

Global, Auto.

To have Radio Resource Management (RRM) automatically set the transmit 
power for all 802.11a Cisco Radios at periodic intervals:
>config 802.11a txPower global auto

To set transmit power for all 802.11a Cisco Radios to power level 5 (lowest):
>config 802.11a txPower global 5

To set transmit power for 802.11a AP1 to global:
>config 802.11a txPower AP1 global

To set transmit power for 802.11a AP1 to power level 2:
>config 802.11a txPower AP1 2

show ap config 802.11a, config 802.11b txPower, config country

config 802.11b 

Use the following config 802.11b command:

•

•

•

 

•

 

•

•

•

•

•

•

•

•

•

 

•

 

config 802.11b 11gSupport

After enabling the Cisco SWAN 802.11b network using the config 802.11b enable command, enable or 
disable the Cisco SWAN 802.11g network using the config 802.11b 11gSupport command. Note that 
you must use this command to enable the network after configuring other 802.11b parameters.
Note that this command only enables the Cisco SWAN 802.11g network after the Cisco SWAN 802.11b 
network is enabled using the config 802.11b enable command. To disable the 802.11a, 802.11b and/or 
802.11g networks for an individual WLAN, use the config wlan radio command.
This command can be used any time the CLI interface is active.

>