Инструкции По Установке для Maytag MLE24PDAWW

1.   Disconnect  power.

2.   Remove hold-down screw and the terminal block cover.
3.   Assemble 3/4" (19 mm) UL-listed strain relief (UL marking  

on strain relief) into the hole below the terminal block opening. 
Tighten strain relief screws just enough to hold the two clamp 
sections together. Install power supply cord through the  
strain relief.

4.   Complete installation following instructions for your type of 

electrical connection:

• Four-wire (recommended method)

• Three-wire (if four-wire is not available)

5.   Remove the center terminal block screw.
6.   Remove the appliance neutral ground 

wire from the external ground conductor 

screw. Fasten under center terminal block 

screw.

7.   Connect the ground wire of the power 

supply cord to the external ground 

conductor screw. Tighten screw.

8.   Connect the neutral wire (white or center) 

of the power supply cord under the center 

screw of the terminal block. Tighten 

screw.

9.   Connect the other wires to outer terminal 

block screws. Tighten screws.

10.  Tighten strain relief screws.
11.  Insert tab of the terminal block cover into 

slot of the dryer rear panel. Secure cover 

with hold-down screw.

Four-wire power supply cord must have four, No. 10 copper wires and match a four-wire 

receptacle of NEMA Type 14-30R. The fourth wire (ground conductor) must be identified 

by a green cover and the neutral conductor by a white cover.

■  If local codes do not permit the connection of a neutral ground 

wire to the neutral wire, see “Optional 3-wire connection” 
section.

■  A 4-wire power supply connection must be used when the 

appliance is installed in a location where grounding through the 
neutral conductor is prohibited. Grounding through the neutral 
is prohibited for (1) new branch-circuit installations, (2) mobile 
homes, (3) recreational vehicles, and (4) areas where local 
codes prohibit grounding through the neutral conductors.